How to Change KEP Italia Cromo 2.0 Front & Rear Panels

How to Change the Panels on Your KEP Italia Cromo 2.0

Want to switch up the look of your KEP Italia helmet? Changing the front and rear panels on your Cromo 2.0 is quick and easym just follow the steps below. You can also use the visuals for a smooth step-by-step guide.

Step-by-Step Instructions

1. Remove Liner & Visor: Take out the inner liner and detach the front visor from the helmet.
2. Remove Front Panel: Use a small Phillips screwdriver to loosen the two screws holding the front panel in place.
3. Unhook Front Panel: Gently lift and unhook the panel from both sides.
4. Remove Rear Panel: Firmly pull the rear panel upwards and wiggle it to detach.
5. Install New Front Panel: Align the hooks of the new front panel with the helmet’s slots and push it into place.
6. Secure Front Panel: Reinsert and tighten the screws.
7. Install New Rear Panel: Align the hooks and push firmly until you hear a “CLICK”.
8. Reinstall Visor & Liner: Put the liner and visor back into position.

Visual Guide: Changing the Front Insert

Visual Guide: Changing the Back Insert